This is a very nice arm and exactly like - or even better than expected! Here's the installation tip - as this is a square arm (approx 1" on each side) be sure that the tile or wall is cut to allow it to spin properly... the square arm will actually need to go into the wall a bit... and everyone knows that a 1" square arm requires about a 1.5in hole or else the arm will not rotate to tighten up... Our tile person cut a square hole that was big enough for a round arm to be installed - but not this square... so off to get a dremel 1.5" diamond cutting wheel and opened this hole up a bit - see pics. Enjoy!