Well, the light is beautiful. It is a nine out of 10 on the difficulty scale to put together. I ended up using very large wrenches and clamps to twist and move the bars which are steel and hard to move so that the alabaster stone pieces could be installed. I believe there was 104 screws that had to be installed and less than about 10 fit. The rest of these were all off slightly because of the smaller holes in the alabaster. It was also a problem as I screwed them in, and it would get crossfeed as you try to unthread it then the round cap on the outside of the small screw would unscrew and it became even more difficult. I think the fit finish of it is atrocious, but once I spent about 5 1/2 hours Installing the pieces, the hanging light itself is beautiful.