I installed this sink myself. It is an *advanced* DIY project. PROS: 18 gauge stainless steel, and it looks good. CONS: 1) A template is not included. You must make your own template. (Hint – we put masking tape on the counter and traced the outline of the sink on the masking tape.) 2) If you must enlarge the hole “Draw the cut-out line 1/4” inside the sink line.” That’s right – you only have 1/4” between the edge of the hole and the edge of the sink! 3) The edge of the sink had a slight arch above the counter top. I thought this could be corrected with the clips. (Read on …) 4) The clips are L-shaped. If you cut the hole perfectly, the clips work fine. If the hole is not exactly 1/4” from the sink edge then either the clips will be knocked off when you install the sink; or the bottom part of the clip that contacts the counter will slant as you tighten the clap. If the clip slants you cannot tighten the clamp sufficiently to remove arch in the sink edge (see item 3 above). To see the actual clips and the bottom of the sink go to https://youtu.be/YxaX2orbCfQ?t=78 .