Additional Features

• The square back plates and side posts of our 800mm stainless steel single towel rail enhance the distinct square features of this range that is designed to suit most bathrooms. It is designed to hold two folded bath towels/sheets or one unfolded towel/sheet. You can cut the rail to your preferred size simply by removing the horizontal bar and cutting on site.
• Width is customizable by removing the horizontal bar and cutting on site.
• Can hold a full-width bath towel to air dry, or 2 single folded bath towels.
• Stainless steel construction ensures durability, the sturdy horizontal bar won’t sag under the weight of damp towels.
• Fixing system: RIGID Loc Mounting system. The innovative, one-of-a-kind RIGID Loc Mounting system was engineered to ensure our bathroom accessories remain locked in place and to prevent constant retightening and maintenance of loose or wobbly paper holders, towel rings, and other accessories. This product uses our patented RIGID Loc Mounting system, designed to ensure the bathroom accessory remains secure to its mounting and will not wobble loose.
• Material: Grade 304 stainless steel is the finest material choice for our bathroom accessories because its natural corrosion resistance properties prevent rusting, staining, peeling, flaking, or chipping. Grade 304 stainless steel is also a hygienic material – it is nonporous and does not collect bacteria or algae. Stainless steel does not require any protective coating, making this material ideal for the bathroom environment. The shiny polished finish of stainless steel is often confused with a chrome finish, however, the two could not be more different. While stainless steel will not peel or flake, chrome products on the other hand are susceptible to chipping and pitting due to the nature of a coated product.
• Suitable to be installed: Masonry or concrete surface (wall fixings supplied), tiled surface (wall fixings supplied), dry wall-mounting onto stud (wall fixings not supplied), glass (using bathroom butler glass mountings - optional extra).
• Cleaning and care: To keep your product in pristine condition, simply wipe it down with a warm damp cloth and then buff dry with a microfiber cloth. You could also, on occasion use a chlorine-free stainless steel cleaner to maintain the shine. If you use stainless steel polish, make sure it is abrasive-free. When cleaning wall surfaces around your bathroom accessories do not use any household detergents that may contain chlorine-based chemicals such as bleach as it will cause permanent damage to the surface of the stainless steel product. Clean regularly with a warm damp cloth, and then buff dry with a clean dry cloth. Do not use the rough end of a kitchen sponge to clean your bathroom accessory. To remove any small blemishes or fine scratches, use a non-abrasive metal polish. Do not clean your bathroom accessory with any kind of acid-based chemical, tile cleaner, or detergents that contain chlorine, as these may contaminate and damage the surface finish.
• Easy to install.
• Tools needed (not supplied): Drill & drill bits, 1/4″ (6mm) diamond drill bit – if drilling through ceramic tiles, 1/4″ (6mm) masonry drill bit – if drilling into masonry (brick), measuring tape, ph2 screwdriver, pencil, spirit level, Fischer UX 6 plastic plugs (4 pieces), wall screws (4 pieces), 3/32″ (2.5mm) Allen key (1 piece).
• Installation tip: Check for water pipes before deciding where to drill. In Masonry walls, always drill a smaller pilot hole first for better sizing and location accuracy.